Endless Hot Water
Endless Hot Water | Tankless Water Heater Install | Plumbing | Pikeville
Imagine stepping into your Pikeville shower and being greeted by a steady, never-ending stream of perfectly heated water—no more racing the clock or staggering schedules. HEP’s master plumbers make that luxury an everyday reality with our expert tankless water heater install services, replacing bulky, inefficient tanks with compact units that heat water on demand, trim energy bills, and free up valuable space.
From the first phone call to the final pressure test, we handle everything in-house, arrive on time, and leave your home cleaner than we found it. Whether you’re upgrading an aging system or building your dream bath retreat, trust HEP to deliver endless hot water, rock-solid workmanship, and the hometown care Pikeville families have counted on for decades.
FAQs
How does a tankless water heater provide endless hot water?
Unlike storage tanks that heat and re-heat 40–50 gallons at a time, a tankless water heater uses high-output burners or heating elements to warm the water only when you open a tap. Cold water flows across a heat exchanger and exits at the set temperature within seconds, so there is no “tank” to run out. As long as the unit is correctly sized for your household’s simultaneous demand, you’ll have a continuous supply of hot water for showers, laundry, and dishwashing.
What size tankless unit do I need for my Pikeville home?
Sizing is based on two factors: 1) the temperature rise between Pikeville’s incoming water (roughly 55 °F) and your desired hot-water set-point (usually 120 °F), and 2) the total gallons per minute (GPM) you expect to use at one time. A typical three-bathroom home that might run two showers and a dishwasher at once generally needs a 9–11 GPM gas unit or a large 27 kW electric unit. Our technicians calculate your peak demand, perform a site inspection, and recommend the model that will keep up without overspending on capacity.
Are tankless water heaters energy-efficient and will they lower my utility bills?
Yes. Because tankless systems heat water only on demand, standby heat loss is eliminated, saving 24-34 % on energy compared with standard tanks, according to the U.S. Department of Energy. Gas models carry EF ratings up to 0.99 and qualify for federal tax credits and Kentucky utility rebates. Actual savings in Pikeville vary with usage patterns, fuel type, and the efficiency of your old heater, but many customers report $80–$150 per year in reduced gas or electric costs.
How long does installation take and will my water service be interrupted?
A straightforward replacement of a gas tank with a tankless unit normally takes 4–6 hours. Converting from electric to gas, relocating the heater, or upgrading venting can extend the job to a full day. We shut off water and fuel lines only during the tie-in phase, usually 1–2 hours, so disruption is minimal. Our Pikeville crew arrives with all permits, removes your old tank for recycling, tests the new system, and cleans the workspace before we leave.
What maintenance does a tankless water heater require in Pikeville’s water conditions?
Pike County’s moderately hard water (6–8 grains per gallon) can cause scale buildup on the heat exchanger. To protect efficiency and warranty coverage, we recommend an annual maintenance visit that includes: 1) descaling/flush with food-grade vinegar, 2) cleaning the inlet filter, 3) inspecting the burner or heating elements, and 4) checking venting and gas pressures. Installing a whole-house sediment filter or a small scale-reduction system at the heater inlet further extends the unit’s service life.
Do I need to upgrade my gas line or electrical panel for a tankless installation?
Possibly. High-output gas tankless models require ¾-inch gas lines and up to 200 k BTU input, more than older 40-gallon tanks. If your existing line is undersized, we’ll provide a cost-effective upsizing estimate. Electric tankless units draw 100–120 A at 240 V and need multiple 40–60 A breakers; homes with 100 A service typically need a panel upgrade to 200 A. Our licensed plumbers and electricians assess your infrastructure during the site visit and include any necessary upgrades in the written quote.